xcluma 5A 75W Xl4015 Cc Cv Dc-Dc Lithium Battery Charger Step-Down Module
★★★★★
(8 customer reviews)₹359.00
Added to wishlistRemoved from wishlist 0
- Input voltage range:4?38VDC(Note:input voltage not exceeding 38V) Output voltage range:1.25-36VDC adjustable
- Output current: 0-5A Output power: 75W High efficiency up to 96% Built in thermal shutdown function
- Common Problem: Output Voltage is not adjusting: Turn CC Potentiometer anticlockwise 30 rounds, before adjusting Voltage. Caution: When using this product, the input ground and output ground of the module should not be together, which will cause the current sampling resistor on the back of the board to be bypassed, so that the module can not adjust the output current, it is easy to connect the load. Burn the power chip on the module .
,
Specification: xcluma 5A 75W Xl4015 Cc Cv Dc-Dc Lithium Battery Charger Step-Down Module
|
8 reviews for xcluma 5A 75W Xl4015 Cc Cv Dc-Dc Lithium Battery Charger Step-Down Module
4.0 out of 5
★★★★★
★★★★★
4
★★★★★
2
★★★★★
1
★★★★★
0
★★★★★
1
Write a review
Show all
Most Helpful
Highest Rating
Lowest Rating
Add a review Cancel reply
Related Products
Added to wishlistRemoved from wishlist 0
₹167.00
Added to wishlistRemoved from wishlist 0
₹445.00
Added to wishlistRemoved from wishlist 0
₹639.00
Added to wishlistRemoved from wishlist 0
₹2,999.00
Added to wishlistRemoved from wishlist 0
₹82.00
Added to wishlistRemoved from wishlist 0
₹213.00

xcluma 5A 75W Xl4015 Cc Cv Dc-Dc Lithium Battery Charger Step-Down Module
₹359.00


ADITYA –
Good item, works alright, very useful for multi-use around the lab.
Placeholder –
The circuit functions fine as defined. The built quality is impressive, but price a little high. Thank you.
Ankit kushwaha –
Awesome product I give 45v input and it’s working good
Amazon Customer –
The output voltage remains same as the input voltage. Not possible to change throgh voltage adjester.
Swarna –
Good
Vijay –
Good one
Swarna –
I have found : xcluma is as reliable as Amazon. All functions working as described, only one suggestion : there should have been the provision for a heatsink as I have used it up to 3 ampears at 14.2 volts continuously
Gagan K. –
Used it for charging 12.8 volt,30AH battery,Charged the battery once only then on second time connecting a charged battery,Its IC was blown away,then ordered the another one,same issue,Circuit in it probably cannot stop current from battery to its primary section,Input and output section is not properly isolated.May be it can charge small lipo battery,not sure,but did not work for 30AH battery…