MZHOU NVME M.2 SSD M Key to PCI-e 3.0 x1 Host Controller Expansion Card,Supports M2 NGFF PCI-e 3.0, 2.0 or 1.0, NVME or AHCI, M-Key, 2280, 2260,…
₹600.00
- VERSATILE APPLICATION&M KEY PCIE SSD CARD:Adds an M.2 PCIe SSD (M-Key) to your PCIe-equipped desktop computer (Windows 11,10, 8, 7, XP, etc.) to significantly increase speed and performance. Supports PCIE 3.0 motherboards and is backward compatible with PCIE 1.0 and PCIe 2.0. Also supports PCIE x1 bus slot.
- HIGH PERFORMANCE: The NVMe PCIe card allows you add M.2 PCI-e NVME SSD to your motherboard without M.2 slot, perfect solution for PC upgraded.
- APPLICABLE SSD HARD DRIVE:The M.2 PCIE adapter ONLY supports PCI-E NVME based M Key (NVMe & AHCI), NOT supports any SATA based SSD. Fit for PCIE x1/x4/ x8/ x16 slot.
- EASY SETUP: No driver installation required (if an exclamation mark appears after installing the adapter, ask the SSD manufacturer to offer the NVME driver for SSD for PCIE). Includes both flat and full profile brackets for installing flexible system chassis, ideal for 2U enclosures.
- INTUITIVE DESIGN:Suitable for 2230, 2242, 2260 and 2280 M.2 SSDs (NVME or AHCI) over several mounting holes ! NOTE: Systems released before 2015 may not support NVME SSDs. Please ask your system provider for compatible SSD.
,
Specification: MZHOU NVME M.2 SSD M Key to PCI-e 3.0 x1 Host Controller Expansion Card,Supports M2 NGFF PCI-e 3.0, 2.0 or 1.0, NVME or AHCI, M-Key, 2280, 2260,…
|
13 reviews for MZHOU NVME M.2 SSD M Key to PCI-e 3.0 x1 Host Controller Expansion Card,Supports M2 NGFF PCI-e 3.0, 2.0 or 1.0, NVME or AHCI, M-Key, 2280, 2260,…
Show all
Most Helpful
Highest Rating
Lowest Rating
Add a review
Related Products
MZHOU NVME M.2 SSD M Key to PCI-e 3.0 x1 Host Controller Expansion Card,Supports M2 NGFF PCI-e 3.0, 2.0 or 1.0, NVME or AHCI, M-Key, 2280, 2260,…
₹600.00
Alienbug –
📝 DESCRIPCIÓN
Tarjeta de expansión PCIe 1 a 4, con adaptador USB 3.0, ideal para aumentar puertos PCIe en placas base. 💻🔌
Modelo similar en Amazon con salidas usb-c y usb-a: https://amzn.to/4iMkgRt
🧾 ESPECIFICACIONES
– Interfaz: PCIe x1 (compatible con x4, x8, x16)
– Puertos: 4 x USB 3.0 (señales PCIe, no USB estándar)
– Compatibilidad: Windows (XP/7/8/10), Linux, DOS
– Material: Disipador de calor de aluminio
– Dimensiones: 120 x 55 x 75 mm
📦 CONTENIDO
1 – Tarjeta de expansión PCIe 1 a 4
1 – Manual (no incluido en mi caso)
💶 PRECIO
– 4 de Marzo de 2025: 17,99€
🟢 PROS
• Aumenta los puertos PCIe en placas base con solo una ranura PCIe x1.
• Compatible con sistemas Windows, Linux y DOS.
• Diseño compacto con disipador de calor de aluminio.
• No requiere cable de alimentación adicional.
• Conexiones USB chapadas en oro para mayor durabilidad.
🔴 CONTRAS
• No incluye manual de instrucciones.
8️⃣ VALORACIÓN
Cogí esta tarjeta de expansión para aumentar los puertos PCIe en mi placa base, y en general ha cumplido con su función. Lo primero que destaco es su facilidad de instalación: solo hay que conectarla a una ranura PCIe y listo. No requiere cable de alimentación adicional, lo que simplifica el proceso y tampoco la necesidad de poner drivers ni nada en Windows 10.
El diseño es compacto y cuenta con un disipador de calor de aluminio, lo que ayuda a mantener la temperatura bajo control durante su uso. Sin embargo, es importante tener en cuenta que los puertos USB 3.0 no son estándar, ya que utilizan señales PCIe. Esto significa que no se pueden conectar dispositivos USB tradicionales, como discos duros externos o memorias USB.
✅ CONCLUSIÓN
Es una tarjeta de expansión práctica y económica, ideal para aumentar los puertos PCIe en placas base con ranuras limitadas.
👍 RECOMENDABLE.
✳️ Espero que mi comentario ✍️ te haya podido servir de ayuda 😃
MiguiOceano –
It took me a little while to figure out why this wouldn’t go in properly in my HP Z840. Eventually I figured out that the locating tab at the top that goes in the notch 90 degrees from where the screw hole would be, was wider than the notch itself. I compared it to the other cards in my system and it was noticably narrower and shorter. Annoyingly, in trying to fit the card, I bent over the locating tab and had to bend that upright with some needle nose pliers, before dremmeling the notch a bit bigger.
The other issue I had was that the Intel drive I bought sits about 1.5mm off the PCB when inserted into the connector, so using the two screws closest to the connector was impossible as they just didn’t reach. The ones at the back were just about long enough, but the drive is mounted at a very slight angle to the card/adapter as a result. Surely the connector is at a standard height above the bottom of these U.2 drives, so the connector should be sized appropriately – or otherwise there should be a spacer and longer screws provided to mount the drive parallel to the PCB.
Once the fitment issues were resolved, the card itself functions perfectly. The drive is recognised and performs really well, and my Z840 boots off of it with no issues. And this card is a fair bit cheaper than comparable adapters, so I’m prepared to cut it some slack, given I was cheaping-out for my home office workstation. For anyone considering it for a more enterprise/corporate environment, if your staff have to f about for an hour getting it to fit, you’ve wasted more money than you saved, so pay the extra and get something designed a bit better.
Ravi Kumarswamy –
good, but hanging sometime
MSP!… –
This card has disconnected the Crucial NVMe P3 SSD several times during the operation and the I/O speed is not more than 500MBps. A better bet would be https://amzn.eu/d/26tZdBQ which offered stable drive availability and faster I/O upto 1700MBps.
B Z. –
(Tcsunbow NGFF (M.2) 2242 SSD 120GB) testé sur
(Carte PCI-E vers USB 3.0 PCI Express incluant 1 USB C et 2 ports USB A)
test de vitesse sur un fichier de 2.5gb de (c:/) à (c:/) donne une vitesse d’environ 230Mb/s
HARA PRASAD PATRO –
Excellent
Amazon Customer –
missing low height bracket, cannot fix in sff cabinet. item is not returnable
Ashish Kumar Khobragade –
Vgood product speed bases on the nvme SSD speed Work smoothly
Good work experience
Amazon Customer –
Works as expected
MiguiOceano –
2年近く使っているけど特に問題は起きていない。
うちのPCのマザーボードでは、そのままではOSの起動が出来ないがClover EFI bootloaderを使えば問題なくOSの起動が出来る。
MSP!… –
Installed and working. Don’t know how long it will last, so lets hope for the best
Alienbug –
最初は問題なく使えたが再起動やシャットダウン後のPOSTが成功しない現象が発生するように
ネット上のドライバ配布サイトにドライバと新しいファームウェア(JMB585用)があったので更新したところ無事POSTできました windows11を使っていますがドライバ更新の際にwindows側の起動オプションでドライバの署名の強制を無効にしないとこのデバイスをファームウェア更新ソフトが認識してくれません
Jas –
wont show your NVMe ssd in the boot menu neither in bios so not worth if you planning to install your operating system using the help of this